Home FAQ Search Memberlist Usergroups Register Profile Log in to check PMs Log in
Chat Calendar Classified Ads Auctions Field Finder Store Finder Feedback

Post new topic   Reply to topic    WARPIG.com Forum Index -> Mini -> Invert mini settings.
View previous topic :: View next topic  
Author Message
GLDLUVR



Joined: 02 Nov 2008
Posts: 6

PostPosted: Sun Nov 02, 2008 1:36 am    Post subject: Invert mini settings. Reply with quote

Does anyone have any suggestion on the settings which are the ultimate
settings on the mini,I.E Dwell.
On compressed air,Empire B2 loader.
I need the fastest speed attainable,Eyes on.
I have never chopped a ball in this gun.
Back to top
View user's profile Send private message
Paintzapper



Joined: 09 Oct 2008
Posts: 436
Location: Central Florida

PostPosted: Mon Feb 02, 2009 1:46 pm    Post subject: Reply with quote

ok i was looken around for yas, i ran across this information. now im not an owner of a mini nor do i know much about them, this is just what i found:

Quote:
for efficency
1 turn psi to 190
2 turn backcap out(stock dwell) until you chrono at your field limit
3 drop dwell a ms at a time or so till you see a drop in fps
4 if you see no drop in fps by the time youre at 1 blink, lower your psi till you see a dropoff in fps.
5 once you see a drop due to either dwell or psi, turn whichever one dropped it back up .5 ms or 10 psi to be safe.
6 make sure youre at your field limit with decent consistency. if you see consistency issues or blowback issues, try upping your dwell and lowering your psi a little.

to be gentle on paint.
1 turn your dwell as high as it goes on your board.
2 turn your backcap 3 turns out
4 lower psi until you either
A stop cycling fully(feed 2 at a time to tell)
B get blowback (feed 2 at a time to tell)
C drop your fps below your field limit
5 if A happens, up your psi until you do cycle fully. if B happens up your psi until you stop the blowback. if C happens turn your psi back up until you are at your field limit
6 after all that, you should have a gun on very low pressure, but still has kick??? thats because it has about 4x the dwell it needs. lower your dwell one ms at a time till you see a drop in fps.
7 once that drop happens bump it back up 1 ms. check for consistancy, half cycling, or blowback.
8 if you see consistency issues or blowback issues, try upping your dwell a little.
__________________

thisll work for both stock bolt and v2. although with stock bolt youll see some half cycles before you go below 300 fps when going for lowest pressure.


now if you want speed, a new board? not one for max speed lol so i wouldnt know.
Back to top
View user's profile Send private message
GLDLUVR



Joined: 02 Nov 2008
Posts: 6

PostPosted: Tue Feb 03, 2009 12:09 am    Post subject: Reply with quote

This helps loads, Thank you for your time.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    WARPIG.com Forum Index -> Mini All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB 2.0.23 © 2001, 2002 phpBB Group
WARPIG Template built from Odyssey Template by Will Mullis