[PFD247]

"im a new player in need of help with gun set up" i have an 09 proto rail with a ultralite barrel a rotor loader and a 68/45 ninja tank and it shoots great. I then added a OLED virtue board and the marker became louder and less air efficient what can i do to fix it? I dont know anything about all the settings it has like dwell, debounce, anti mechanical bounce, anti breech bounce, anti bolt stick, and ramp percentage. Is there a perfect set up? please help

[DaveA]

sounds like dwell is set too high. Do you have the manual?
If you know how to set the board, the RED one is dwell and default is 25. Lowering that number will probably require raising the input psi, but do that over a chrono.
I'd leave everything else on the default setting, then if you want start dropping the Debounce number down by one or two. ABS is only useful if you're experiencing first shot drop off (FSDO) which generally is caused by the bolt not breaking free from it's prone position quite fast enough to get forwards fast enough to acheive a full gas dump through the bolt. It doesn't get a full gas dump because the dwell setting pushes the bolt back before it can dump fully, so the ABS setting increases the dwell setting for that first shot, hopefully allowing the full dump.
FSDO can be caused by overlubing, dirty lube, overly tight orings.
Don't bother with Ball in Place settings yet. It's for super fine tuning.
_________________
Accuracy Formula
25% Skills + 25% gun +30%Paintball quality+ 15%luck +10% Range = Accuracy imfho